Joint Rolling Methods

For those of you who already know how the basics and want to move on to the more advanced joint-rolling methods, read on.

The Knee Trembler

Take out two rolling papers then stick them together at a 45° angle.
Place the mixture and roach onto the paper.
Roll the first paper down (the one which contains the mixture).
Wet the second paper, wrap it around the first one to seal the end of the joint.

Get two rolling papers, sticking them together with their sticky strips forming a straight line. Make sure that they overlap by about one-fifth of their size.
Now take out a third rolling paper and stick it to the back of the first two rolling papers. Make sure that you stick it right in the center.
Add the mixture, evenly distributing it, as well as the roach.
Roll the joint as you would a normal one.

Grab two rolling papers and stick then together by sticking the gummed strip of one to the edge of the other rolling paper.
Now take a cigarette and remove its filter by squeezing at the base using your thumb and forefinger. When you see enough of the filter showing, pull it out.
Replace the filter with a roach. Make sure that it is the same size and shape as the one you took out.
Cut the cigarette with a sharp knife (so as to make a nice, clean cut) about 1cm from the roach.
Place the mixture onto your rolling paper to replace the tobacco from the cigarette. Place your now-disguised roach onto the end of the rolling paper. Make sure that you place enough mixture on your paper to make it look like a cigarette.
Roll the joint into an even cigarette shape with the roach poking out at the end.
If the joint feels loose, that’s normal. Take a gum strip from another rolling paper and wrap it around the filter to secure it.

Combine two rolling papers together forming a square, leaving one gummed strip side along one side.
Then take a third rolling paper, sticking it face down at the edge of the first two rolling papers.
Place the mixture, making it into a cone shape. You can trim away excess paper if you want, since there is plenty of space in the joint for the mixture.
Roll the joint and then twist the end to secure the third paper.

Stick two rolling papers together, making sure that the sticky strips form a straight line.
Get a third rolling paper and fold it in half. Leave the sticky strip on the outside.
Lick the gummed strip and stick the third paper in between the first two rolling papers.
Pull out the third rolling paper again before the strip dries. This should leave enough glue on the others to make them stick together.
Now stick a fourth rolling paper to the lower righthand side of the joint.
Grab a fifth rolling paper and stick it to the top of the two rolling papers.
Rip the fourth paper in half diagonally to make it better for rolling into a cone shape.
Place the weed onto the paper, packing it into a nice, firm cone shape.
Roll the joint, making sure that your fingers are supporting its extra length and seal.

Stick two rolling papers together, making sure that the sticky strips form a straight line.
Get a third rolling paper and fold it in half. Leave the sticky strip on the outside.
Lick the gummed strip and stick the third paper in between the first two rolling papers.
Pull out the third rolling paper again before the strip dries. This should leave enough glue on the others to make them stick together.
Slowly and carefully roast a cigarette over a moving flame (from a match or lighter), heating the tobacco inside, until the papers turn brown. This will burn off a bit of the tar and nicotine.
Now turn over your rolling papers on a flat surface. The right side with the sticky strip should be facing down and the reverse side should be facing you. Add the mixture and roach to the reverse side.
Roll the joint with the gum strip outside. Seal the joint, leaving the excess paper.
When the joint is sealed, light the excess rolling paper starting from where your roach is placed and let the flame burn the excess paper.